| Tools Required:
|
Flathead screwdriver (maybe) |
| |
|
|
|
 |
 |
| |
2. Turn the button
color-side-down and place your index-finger and thumb on either
of the two button trigger-pads.
|
|
|
3. Press them gently toward the center, enough
to allow the trigger-pads to fit into the button-casing shaft.
|
4. Slide the top half (trigger-assembly, separator
disc, and color dome) down and out from the bottom half (button
casing). Set the bottom half aside.
|
 |
 |
| 5. Take the top half in hand and
rotate it until you see this side where the color dome and trigger-assembly
have their tabs. |
6. Remove the color dome by either
pushing up on it's tabs with your thumbnail, or by placing a
screwdriver between and rotating it firmly.
This should separate the top half into it's three components:
color dome, separator disc, trigger-assembly.
|
 |
|
7. If your separator disc is stuck
within the color dome (as shown above) try tapping the color
dome, face down, against a carpeted floor.
Or, one could attempt to pry it out by exploiting the tabs on
the separator disc. |
|
