|
|
 |
 |
| 1. Place your
Ransai face up and position the button over its cradle. |
2. Put the casing
shaft into the cradle hole, and let graviy pull the button
through. Note that there are tabs on the side of the button
casing that need to be lined up with the tabs in the cradle,
this will allow the button to sink further and rest level
with the shell.
|
|
|
3. Turn the controller back over.
|
4. And place the ring back on the shaft.
|
 |
|
5. Insert
the microswitch.
And you are done.
|
|
